E-Que E1/T1 Interface Card

The E-Que E1/T1 interface allows the Eclipse HX matrix to connect to FreeSpeak II antennas and FreeSpeak II antenna splitters.

Each E-Que interface comprises:

• A front card with a reset button and various status indicators.

• A rear card with eleven RJ-45 ports giving eight standard ports, DECT sync in and out and a LAN port for diagnostic use.

Each E-Que front card has status LEDs for power, port activity and LAN status. The port activity LEDs show when

• A device is connected to an E1 port.

• A connection has been established between the E1 port and the connected device.

A total of four E-Que, IVC-32 or LMC-64 interface cards may be fitted to an Eclipse HX-Omega unless the matrix is fitted with a Power-One/Bel Fuse PSU. If the matrix has a Power-One/Bel Fuse PSU, up to six E-Que, IVC-32 or LMC-64 cards may be fitted with the following condition:

• You can only have four wireless E-Que cards

• You can only have four E-Que cards with EM signaling enabled.

For the order in which all interface cards must be installed to the Eclipse HX-Omega, see Installing Interface Cards.

Note:

The EHX configuration software provides E1 and T1 trunking (see EHX Configuration Software).

Cards slide vertically into the front of the matrix and connect to the backplane.