Connecting to Mains AC Power

Eclipse HX matrices and interface frames (IMF-3)

Eclipse HX matrices have two separate AC power connectors for two separate power supplies in the system. Either power supply will completely power a system, providing 100% power redundancy. If the two power supplies are connected to different AC power sources and one of the power supplies loses power, the other will continue to operate the system.

AC voltage for the matrices and the PSU-101 can be 100 - 240 VAC without any switching or fuse changes.

Each component of the Eclipse HX system requires AC power except for the IMF-3 and some interface modules. The IMF-3 requires an external power supply. The XP-type expansion panels receive power from the panels to which they are connected.

If you are installing an IMF-3, install the DC power cables that connect the power supply to the matrix. For the matrix and each connected component, install and connect the mains AC power cables.

Note: For further information, see Powering System Components.

  

V-Series panels

Each V-Series panel has an external power supply and a removable cradle to hold the external power supply.

AC voltage for these panels can be 100 - 240 VAC without any switching or fuse changes.

I-Series panels

I-Series panels have internal power supplies, with removable AC power cords. The power supplies are universal, operating over a voltage range of 90 - 245 VAC and 50 - 60 Hz. The maximum dissipation is 40 W.

2X10 Touch Desktop panel)

The 2X10 Touch Desktop panel has a 2.5mm Power jack connector with screwlock retention to accept the required input power of 12VDC, 2A.

An AC/DC Desk Top Power Adapter is supplied with the unit. The power adapter has the following specification:

  • Input connector : IEC-320 C14 male receptacle

  • Input AC Voltage range : 100-240VAC

  • Input Frequency range : 50-60Hz

  • Input current : 1.2A

  • Output DC Voltage : 12VDC

  • Output rated current : 3.5A

  • Output connection : 2.5mm DC power plug ( with 1.5meters lead )

Note: Each panel must be plugged into an AC source at its location.

Only connect power supply to earthed supply sockets. Ensure that the power supply is routed to avoid sharp bends, hot surfaces, pinches and abrasion. Refer all servicing to qualified service personnel.

For more safety guidance, see the Safety Instructions supplied with this product.