Upgrading Firmware
There are two ways to upgrade the firmware on the Arcadia Station:
-
Using the CCM web interface. When upgrading from the CCM, you can upgrade all connected resources (for example, transceivers and beltpacks).
-
Using a USB stick (USB A on the front of the Arcadia Station). When upgrading in this way, only the Arcadia Stationcan be upgraded.
| Arcadia Station, FS II IP TCVR, FS Edge IP TCVR |
.ccf |
| FS II beltpack, FS II E1 TCVR |
.fww |
| FS Edge beltpack |
.ccu |
| HelixNet |
See Upgrading HelixNet below |
-
In the CCM, navigate to Hardware > Host > Upgrade.
-
Press Select File and select the file containing the updated firmware.
-
When the file is uploaded, the Upgrade button will be enabled.
-
Press the Upgrade button.
-
The upgrade process will start and the Arcadia Station will reboot before being available again.
-
The new version of the firmware will be displayed in the Hosts panel.
-
Copy the firmware file onto a USB stick. The file must be at the top level of the USB drive, not within any folders.
-
Insert the USB into the USB port on the front of the Arcadia Station.
-
Press the Menu button.
-
Using the rotary controllers, navigate to Administration > Software > Update.
-
The display will show the available firmware files stored on the USB. Select the one you require.
-
Press the 4th rotary encoder. The unit will upgrade and then reboot.
-
To check the current firmware version, in the menu system navigate to Administration > Software > Current. The current software version is displayed in the 4th menu screen.
HelixNet Upgrade
Upgrades to the HelixNet system are included with the Arcadia software. The HelixNet system requires that all connected devices have the same firmware. Therefore, any mismatches that are detected will cause an immediate and automatic upgrade (or downgrade) to the HelixNet devices on connection. The HelixNet system will also upgrade automatically when the Arcadia Central Station is upgraded.
Upgrading using the CCM